Williams Products Inc.  For all your Seal and Gasket needs.
Home Products Concrete Masonry Thermal and Water Protection Custom Designs Tech Data Sealants

Division 4 Masonry

Williams Masonry Control Joint materials are made of quality elastomers, meeting ASTM material standards.  These control joint gaskets provide more than one functional feature for a given application.  These custom designed seals furnish an excellent seal and function as a second line of defense when sealants fail from in-service use.  These sealants will shed water and will reduce sound and thermal transmission.   Shear loads from wind are transferred to the concrete masonry units with our gaskets in control joints.

Cavity Wall Baffle

Everlastic® Cavity Wall Baffle using EVA 200

Compartmentalization of the cavity wall system will equalize the negative pressure within the wall cavity to the exterior positive pressure more quickly and efficiently when using PVC brick vents, cell vents or open head joints.

Everlastic® Neo Seal IV / Column Boxboards

The Neo Seal IV gasket is used as a joint filler, a back -up rod and a compressible material in brick expansion joints.  This multi-functional product provides excellent control during installation because one component is used instead of two, minimizing labor costs at each expansion joint.   Neo Seal IV is an expanded closed cell neoprene material, extruded gasket, with four connected tubes.  The elastomer is non-absorbent and is inert to heat, cold and atmospheric acids.  The specially formed tubes compress to approximately 3-1/4" in overall width when installed in a conventional 3/8" brick expansion joint.   This gasket provides an effective seal against moisture entering the joint causing frost damage.

Everlastic® MF-40, Rubberized Asphalt Flashing

A 40 mil self adhering membrane composed of 32 mils rubberized asphalt adhesive bonded to 8 mil polyethylene film.

Williams-Goodco PVC Brick Vents

The Williams-Goodco brick vent is an injection molded vent made from flexible polyvinyl chloride in an offset "T" shape. When inserted in vertical mortar joints between two bricks, the slotted leg of the vent allows air to pass in and out allowing water to weep out while preventing water penetrating in.

Williams-Goodco CMU Vents All New CMU Weep System

The Williams-Goodco CMU vent is an injection molded vent made from flexible polyvinyl chloride in an offset "T" shape. When inserted in vertical mortar joints between two blocks, the slotted leg of the vent allows air to pass in and out allowing water to weep out while preventing water penetrating in.

Anchor Gaskets

Self Stick, closed cell, Neoprene Gasket perforated & cut to dimensions of anchor back plate.

Control Joints

Williams Masonry Control Materials are designed to prevent destructive cracking in masonry (from temperature and drying shrinkage, differential movement of structural members and surrounding masonry, settling of foundations, etc.) While stress relieving masonry, Williams? materials also seal out moisture and cold air at a reasonable price.

 
You may contact us by;  
Phone:  Toll Free 800-521-9594    or      248-643-6400
Fax: 248-643-7117
Email: Wilpro@williamsproducts.net
Rubber, Neoprene, Foam, Gasket, Seal, Construction. To the best of our knowledge this published information is accurate, however, to determine suitability of material/product for a specific application is the user's responsibility.  Williams Products, Inc. shall not be liable for any loss or damage resulting from inappropriate usage.
Everlastic® is a registered trademark of Williams Products. All other products mentioned are registered trademarks or trademarks of their respective companies.
Contact Williams Products: Phone: 800-521-9594 or 248-643-6400 or Email: Wilpro@williamsproducts.net  Contact Information